DHCP Pool on a WLC

Configure a DHCP pool to assign IP Addresses to the clients :

(Cisco Controller) >config
(Cisco Controller) config>dhcp create-scope client15
(Cisco Controller) config>dhcp address-pool client15
(Cisco Controller) config>dhcp default-router client15
(Cisco Controller) config>dhcp network client15
(Cisco Controller) config>dhcp enable client15

Since the DHCP server is configured on the controller itself, it should point to the controller’s management interface :
(Cisco Controller) config>interface dhcp dynamic-interface vlan15 primary

About Joost van der Made


Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s

%d bloggers like this: